Precautions for operation of belt Slitter:

1. Before using the belt Slitter, it is necessary to check whether the working positions are properly adjusted, and the parts to be lubricated should be filled with lubricating grease in advance. At the same time, it is also necessary to insist on whether the cutting tools on the belt Slitter are sharp.

2. Before working, the belt Slitter should also check whether the machine is abnormal, and input the order to be processed into the computer in advance for inspection.

3. Before starting the belt Slitter, the operator should first ensure that there are no other people around it, so as to avoid injuring other people.

4. Before starting, ensure the normal voltage, current and hydraulic pressure to ensure the safe and effective operation of the equipment.

5. During the operation of the belt Slitter, in order to avoid personal injury caused by hand winding, it should be noted that the running film coil or roll core cannot be touched by hand.

6. When operating the belt Slitter, pay attention not to use knife or hard object to scratch or cut the roller core.

7. After the belt slitter is put into operation, the best working condition of the equipment should be adjusted in time according to the production situation to ensure that the indentation of the slitter is moderate, the slitting is free of burr, and the trimming position on both sides is appropriate.

8. If the equipment is not in use, it should be cleaned and maintained regularly to ensure that it can be used directly next time. For example, when the transmission chains and gears are short of oil every six months,

Grease injection; reducer lubrication, winding shaft bushing and shaft lubrication, air source processor oil lubrication, or regularly check whether the screws of each part are loose, it should be noted that in the maintenance of the belt Slitter, do not use corrosive chemicals to wipe the embossing wheel, rubber wheel and winding shaft.

Principle of belt Slitter:

1. The paper slitting machine needs to cut the whole roll or sheet of raw materials to a fixed length, such as plastic packaging materials, packaging cartons, steel plates, films, leather, wood chips and so on.

2. The slitting length can be set continuously. If the actual slitting length has error, it is easy to calibrate by setting parameters.

3. The slitting control of paper Slitter can be divided into static and dynamic slitting: when the set length arrives, the slitter will stop accurately, then the slitter will start again after static slitting; when the set length arrives, the slitter will send the slitting signal without stopping, and the slitter will cut dynamically in the process of material movement.